Bigboss is extremely proud to announce the arrival of an amazing series of special Props & Accessories by Cricky.

This is the Wishing Well by Cricky.

This package contains a Demo project with an animated Wishing Well Prop. All pieces are separate where needed to allow adjustment and personalization.

Method of use:

1) Load Demo Project
2) Press Play
3) Customize Well with your own Textures.
4) Save Well Prop for later use.

ADDITIONAL NOTES:

Try using Stacking and offsets of multiple sections below the supports..

Scaling of the components is simple.

The Lower Well portion has "TWO" maps.. One for the Flat Surface(s) and another for the outer and inner walls. Adjusting tiling to each will result in better blending of the Flat Surfaces and Faces.

Using "CTRL+M" (Snap-to-Model) should give you a clean stack and then doing an offset spin of the layered pieces by 15 deg. will give you a rough face surface to go with the texture of your choice.
This model uses the same material for both the base and the Roof.

The supports and Crank assembly were created and animated from Standard Building blocks, then "collected" as an animation to allow quick perform action.

The rope hanging down is simply a soft cloth rope pinned using Nvidia Physx parameters, with a minor addition of some Wind.

The coils were made for another project but fit nicely around the Roller Assy to simulate a wound up rope.

All you need now is a Bucket and some water and you'll have a Wishing Well you can throw coins in everyday wishing the fun would never end.

Enjoy,



This Prop was created by Cricky.

Have fun!